Commercial Roof Repair & Leak Detection in Oklahoma City

Flat Roof • Metal Roof • TPO • EPDM • Leak Detection & Targeted Repairs

Commercial Roof Repair in Oklahoma: What Property Owners Need to Know

Commercial roof leaks in Oklahoma are common due to heavy rain, hail, wind, and extreme temperature swings. Over time, these conditions cause membrane failure, flashing separation, and penetration breakdowns leading to interior damage if not addressed quickly.

Most commercial roofs in Oklahoma City are flat or low-slope systems such as TPO, EPDM, PVC, or metal roofing. These systems require targeted repair and proper leak detection, not guesswork or unnecessary full replacement.

At  A.R.C., we specialize in finding the true source of leaks and repairing them correctly the first time. Our approach focuses on extending the life of your roof while avoiding unnecessary costs.

If left unaddressed, even small leaks can lead to structural damage, insulation saturation, and safety hazards especially near electrical systems. Early detection and repair is the most cost-effective solution for long-term protection.

When Should You Call for Commercial Roof Repair?

If you notice any of the following, it’s time to have your commercial roof inspected before the problem gets worse:

  • Active interior leaks or visible water intrusion
  • Water near electrical panels or equipment
  • Recurring leaks or repeated patch failures
  • After storms, hail, or high winds
  • Leaks with no clear or visible source

Early inspection can prevent costly damage and help avoid unnecessary full roof replacement.

If you’re unsure what you’re dealing with, A.R.C. can take a look and give you a clear, honest assessment.

Not Sure What’s Causing Your Roof Leak?

We can take a look, identify the issue, and give you a clear, honest assessment.  No pressure and no unnecessary recommendations.

Phone: (405) 664-2755

Real Commercial Roof Repairs & Custom Solutions Completed by A.R.C.

These are real-world examples of how we locate and solve complex roofing problems across Oklahoma.

Curb Removal & Patch

Flat metal panel with stiffening ribs installed after a roof curb was removed and left a hole in the standing seam roof.
Roof curb removed on a government facility. Flat panel with stiffening ribs over additional framing installed and sealed with liquid rubber and UV protective top coating.

Custom Ridge Cap

Extra wide metal ridge cap. It's a stair step design and is flexible and very strong.
This is an extra wide, 24ga, metal ridge cap. It is a custom design with exceptional strength and flexibility.

Metal Roof Patches

Commercial educational facility near Henryetta, OK. Removed pipes and installed metal roof patches on low slope standing seam roof.

Note

Marker 1

Low slope roof - patches not visible from the ground

Pipe Penetration Coating

Government facility in Texarkana. Gas pipes going to roof top units on an exposed fastener R panel roof. Liquid rubber coating with UV topcoat
Mesh reinforced liquid rubber "pipe boot" with UV topcoating and polyurethane perimeter sealant.

New Perimeter Trim

Metal shop building in Oklahoma City. Old perimeter trim removed and new gutter and trim installed.
Steel building in Oklahoma City with PBR roof and wall panels. The old sculptured trim was removed and replaced with new sculptured gutter and rake trim and mitered the corners.

PVC prep to reseal

Roof top unit on a pvc single ply roofing system in Duncan, OK. Leak repair preparation around the unit.
Roof top unit on a pvc single ply roof was leaking. Removed repair tape, cleaned the surface and heat welded repairs as needed.

Retrofit

Retrofit roof sub framing system to install a new metal roofing system.
This is a retrofit sub framing system over an existing standing seam metal roof. Unfaced insulation is added in the cavity and a new standing seam roof is installed.

Standing Seam

New standing seam metal roof system with sub framing attached to a CMU block structure.
CMU block construction concession stand in Paul's Valley, Oklahoma. Sub framing attached to block with a commercial standing seam metal roof system and shadow trim perimeter flashing.

TPO solution - Ridge to uphill curb

TPO with EPS infill repair over a PBR panel metal roof near Edmond OK.
This TPO with EPS infill was used uphill of a roof top unit that had ongoing leaks for years. A custom diverter was built uphill of the RTU and covered with the TPO which extended up to and over the ridge.

TPO solution for penetrations

TPO with EPS infill on a trapezoidal standing seam metal roof on an Francis Tuttle facility in Oklahoma City. Used to seal existing penetrations with leak issues.
TPO with EPS infill used on an educational facility in OKC with metal roof leaks around penetrations placed closely together. This solved ongoing leaks over several years.

Commercial Roof Repair FAQ (Oklahoma City)

These are common questions we hear from Oklahoma property owners dealing with roof leaks and repairs.

Independent Commercial Roof Inspections in Oklahoma City

A.R.C. provides independent commercial roof inspections focused on accuracy, honesty, and long-term value.

Unlike many contractors, we do not push unnecessary replacements. Our goal is to identify the true condition of your roof and recommend only what is needed.

Our inspections evaluate:

  • Roof membranes (TPO, EPDM, PVC)
  • Metal roofing systems and seams
  • Flashing and penetrations
  • Drainage systems and water flow

We provide clear findings that help property owners:

  • Prioritize repairs
  • Plan budgets
  • Avoid costly surprises

In Oklahoma’s harsh climate, regular inspections are one of the most effective ways to extend the life of a commercial roof.